User guide

Reference
Phone Feature Codes
Page 60 Mitel
®
5000 CP Administrator Phone Guide – Issue 3.2, September 2009
Directories
307
(Display phones Only) Allows display phone users to search for
extension numbers or System Speed Dial numbers. The number
can then be dialed, if appropriate.
Display Outside Party Name
On/Off
379
(Display phones Only) When the phone user enters this feature
code, while connected to a CO call that has outside party name
information, the display will toggle between the caller’s name and
number. If there is no outside party name or the Expanded CO Call
Information On Displays flag is disabled, the user will hear a burst
of reorder tone and see the CANNOT ACCESS FEATURE display.
If the Display Outside Party Name On/Off feature code is
programmed in a user programmable button with a lamp, the lamp
will be lit when the outside party name is enabled and off when the
outside party number is enabled.
Display Time/Date (ITP)
Show IP Address (SIP)
300
(Display phones Only) Temporarily displays the system date and
time, user name, and extension number during a call or when other
displays are shown.
Feature code 300 displays the IP Address of a phone if it is in SIP
mode.
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off
370
371
372
The Do-Not-Disturb feature code halts all intercom calls,
transferred calls, and pages to the phone. The Cancel code returns
the phone to normal operation. The on/off code can be used to
turn Do-Not-Disturb on or off.
Do-Not-Disturb Override
373
(Not used on single line phones) If enabled in the database, allows
the phone user to break through another phone’s Do-Not-Disturb
mode when placing an intercom call.
Enhanced Speakerphone Enable
310
(Digital telephones only) When entered at a digital telephone, this
feature code enables the enhanced speakerphone. Digital
telephones can also use the Special button + Speaker buttons.
Feature Key Default
395
(Not used on single line phones) Phones have user-programmable
feature buttons that can be set to enter feature codes. This code
returns the user-programmable buttons to the database default
values.
Group Listen
312
(Not used on single line phones) Allows a user to transmit a
conversation over the phone speaker while in handset or headset
mode.
Handsfree On/Off
319
(Not used on single line phones) Disables/enables the phone’s
handsfree intercom answering. Incoming intercom calls ring as
private calls if handsfree answering is disabled.
Headset Enable
Headset Disable
Headset On/Off
315
316
317
(Not used on single line phones) The enable code signals the
system that a headset has been connected to the phone. The
disable code returns the phone to normal operation. The on/off
feature code can be used to toggle the feature on or off.
Hold – Individual
336
Places a call on hold so that it can be picked up directly at that
phone or through a reverse transfer from any other phone.
Table 18. Phone Feature Codes (Continued)
Feature Name Code Definition