User guide

Phone and System Administration
Clearing Alarms
Page 40 Mitel
®
5000 CP Administrator Phone Guide – Issue 3.2, September 2009
Clearing Alarms
You can clear a network-wide alarm on the local node only or on every node in the network. To
clear an alarm, you can use either the administrator feature codes or menu buttons.
To use the feature codes to clear alarms:
Dial one of the following feature codes to clear the alarm:
• Clear Network Alarm (9851): This feature code clears network-wide alarms on
every node in the network, but it does not affect system alarms. The Clear Network
Alarm feature code may be entered on any node in the network, but the Send
Network Alarms flag must be set for you to clear alarms on other nodes in the
network.
• Clear System Alarm (9850): This feature code clears all local and network-wide
system alarm displays on your node.
After you enter the feature code, SYSTEM (or NETWORK) ALARM CLEARED appears,
and the highest priority alarm is cleared. If applicable, enter the feature code again to
clear the next alarm in the queue (only one alarm is cleared at a time).
To use menu buttons to clear alarms:
Do one of the following:
• Press the CLEAR ALL ALARMS menu button to clear all alarms. ALL ALARMS
CLEARED appears, and the display returns to the idle menu.
• Press the CLEAR ALARM menu button to clear the currently displayed alarm.
SYSTEM (or NETWORK) ALARM CLEARED appears, and the display shows the
next highest priority, if applicable. If there are no more alarms, the display returns
to the idle menu.