User guide

Phone and System Administration
Programming DTMF or Dial Pulse Signalling
Mitel
®
5000 CP Administrator Phone Guide – Issue 3.2, September 2009 Page 29
Programming DTMF or Dial Pulse Signalling
You can program trunks for dual tone multi-frequency (DTMF) or dial pulse signalling.
To program DTMF or dial pulse signalling:
1. Dial 9932 (9132 in Europe). If a password is required (see page 19), ENTER
PASSWORD appears (otherwise, go to step 3).
2. Enter the password, and then press #. ENTER DATABASE OPTION (1 - 3) appears.
3. Press 3 or the TRUNK menu button. ENTER TRUNK OPTION appears.
4. Press 1 or the INDIVIDUAL TRUNK menu button. ENTER TRUNK EXTENSION
appears.
5. Enter the extension number, or enter a partial extension number, and then press # or the
ACCEPT menu button. The extension information that best matches the partial number
appears. You can use the Volume buttons or the NEXT and PREVIOUS menu buttons to
scroll through entries.
6. Press # or the ACCEPT menu button to accept the entry.
7. Press 4 or the SIGNALLING menu button. ENTER SIGNALLING OPTION (1 - 2)
appears.
8. Press 1 or the DTMF menu button, or press 2 or the PULSE menu button.
9. Press # or the ACCEPT menu button to accept the entry. DATABASE UPDATED
appears.
10. When you are finished with all programming, press the Speaker button or # repeatedly to
exit the programming session.
NOTE
At any time, you can press
*
to return to the previous menu, or press the Speaker
button to exit the programming session and cancel any unsaved changes.