User guide

Phone and System Administration
Programming Trunk Group Toll Restrictions
Page 38 Mitel
®
5000 CP Administrator Phone Guide – Issue 5.0, February 2011
Programming Trunk Group Toll Restrictions
You can program toll restriction classes of service for the trunk groups. See “Programming
Phone Toll Restrictions” on page 19 for more information.
To program trunk group toll restrictions:
1. Dial 9932 (9132 in Europe). If a passcode is required (see page 23), ENTER
PASSCODE appears (otherwise, go to step 3).
2. Enter the passcode, and then press #. ENTER DATABASE OPTION (1 - 3) appears.
3. Press 3 or the TRUNK menu button. ENTER TRUNK OPTION appears.
4. Press 2 or the TRUNK GROUP menu button. ENTER TRUNK GROUP EXTENSION
appears.
5. Enter the extension number, or enter a partial extension number, and then press # or the
ACCEPT menu button. The extension information that best matches the partial number
appears. You can use the Volume buttons or the NEXT and PREVIOUS menu buttons to
scroll through entries.
6. Press # or the ACCEPT menu button to accept the entry. ENTER TRUNK GROUP
OPTION (1 - 6) appears.
7. Press 5 or the TOLL RESTRICTION menu button. TOLL RESTRICTION OPTION (1 - 4)
appears.
8. Select one of the following toll restrictions:
 COS for day or night mode: For Day Mode, press 1 or the COS DAY menu
button, or press 2 or the COS NIGHT menu button Night Mode. SET DAY (or
NIGHT) COS <number> appears. If necessary, scroll to the correct COS. When the
display shows the correct COS, press 1 or the ON menu button to enable the toll
restriction, or press 2 or the OFF menu button to disable it. If applicable, repeat this
step to program additional COS toll restrictions.
 Exempt from ARS: Press 3 or the EXEMPT FROM ARS button. EXEMPT FROM
ARS appears. Press 1 or the YES menu button to enable the option, or press 2 or
the NO menu button to disable it.
 Subject to toll restriction: Press 4 or the SUBJECT TO TOLL menu button.
When the display shows SUBJECT TO TOLL, press 1 or the YES menu button to
enable the option. Or, press 2 or the NO menu button to disable it.
9. Press # or the ACCEPT menu button to continue. DATABASE UPDATED appears.
10. When you are finished with all programming, press the Speaker button or # repeatedly to
exit the programming session.
NOTE
At any time, you can press
*
to return to the previous menu, or press the Speaker
button to exit the programming session and cancel any unsaved changes.