User guide

Phone and System Administration
Programming Phone Toll Restrictions
Mitel
®
5000 CP Administrator Phone Guide – Issue 5.0, February 2011 Page 21
To program toll restrictions for specific phones:
1. Dial 9932 (9132 in Europe). If a passcode is required (see page 23), ENTER
PASSCODE appears (otherwise, go to step 3).
2. Enter the passcode, and then press #. ENTER DATABASE OPTION (1 - 3) appears.
3. Press 1 or the STATION menu button. ENTER STATION EXTENSION appears.
4. Enter the extension number, or enter a partial extension number, and then press # or the
ACCEPT menu button. The extension information that best matches the partial number
appears. You can use the Volume buttons or the NEXT and PREVIOUS menu buttons to
scroll through entries.
5. Press # or the ACCEPT menu button to accept the entry. ENTER STATION OPTION
(1 - 3) appears.
6. Press 3 or the TOLL RESTRICTION menu button. TOLL RESTRICTION OPTION (1 - 2)
appears.
7. Do one of the following:
 Press 1 or the COS DAY menu button for day mode.
 Press 2 or the COS NIGHT menu button for night mode.
SET DAY (or NIGHT) COS XX appears. If this is not the COS you want to program, use
the Volume buttons or the NEXT and PREVIOUS menu buttons to scroll to through the
options. See Table 10 on page 19 (U.S.) or Table 11 on page 20 (Europe) for COS
descriptions.
8. When the display shows the correct COS, press 1 or the ON menu button to enable the
toll restriction, or press 2 or the OFF menu button to disable it.
9. Press # or the ACCEPT menu button to save the COS programming. DATABASE
UPDATED appears followed by the TOLL RESTRICTION OPTION menu.
10. Repeat steps 6 through 8 as necessary to program additional toll restrictions.
11. When you are finished with all programming, press the Speaker button or # repeatedly to
exit the programming session.
NOTE
At any time, you can press
*
to return to the previous menu, or press the Speaker
button to exit the programming session and cancel any unsaved changes.