Installation guide

NORTEL MERIDIAN-1 WITH D82
289
LD11 settings for SL-1 phones
To program analog 2500 type phones
1 On the phone system, go to the LD10 screen to set up the analog 2500 type
phone.
2 Set the REQ, Type, CLS, and FTR prompts as shown in the sample screen.
3 Set the other prompts as applicable. The other prompts shown in the screen
sample are examples. Different settings might be required, depending on the
site. For details on the other prompt settings, refer to the phone system
documentation.
NOTE
Only the prompts needed for this integration appear in this
screen. For details on other prompt settings, refer to the phone
system documentation.
NOTE
Analog phones require special interface boards for QPC789 and
NT8D09AB neon lamps. Without these boards, the neon lamp is
disabled.