Installation guide

UNIVERGE UM8500 INTEGRATION GUIDE
242
Integration
overview
Use this section of the Integration Guide with the Installation Guide.
Integration steps
Follow these steps to set up this integration.
1 Review the system and equipment requirements.
Verify that all equipment, phone system and messaging system server
requirements have been met. See “Requirements,” below.
2 Program the phone system and extensions.
See “Programming the phone system” on page 244.
3 Configure UNIVERGE UM8500 for the integration.
See “Configuring UNIVERGE UM8500 for the integration” on page 245.
Requirements
The steps to set up the NEC SV8500 IP Protims integration require the following:
Equipment
● All Dterm
®
IP phones that will be used with UNIVERGE UM8500 must have
software version 1.2 or newer.
SV8500 phone system
● UNIVERGE SV8500 installed and ready for the integration as described in the
phone system documentation.
● Password encryption type for IP extensions is MD5, see command ASYDL,
index 848, b7=0.
● Fully functional IP PAD cards with VCTI sub-boards.
UNIVERGE UM8500 server
● If the G729 codec is used, the Sipro Lab G729 codec driver must be installed in
the voice mail server. The installation file for this driver is named
sl_g729a_setup.exe and can be found in the Voice Mail\Utilities folder on the
Installation disc.
● A system key that enables the integration and the appropriate number of
voice messaging ports.
NOTE
IP PAD cards provide interface function between IP telephony,
terminals or other devices on LAN, and non-IP telephony,
conventional networks such as PSTN, ISDN, and private networks.
If the telephony network is 100% IP, the IP PAD cards are not
mandatory.