Installation guide

NEC NEAX 2400 WITH SERIAL MCI
157
4 Specify a Service Feature Restriction Class (SFC) for the voice messaging
ports, see the ASFC command. It is recommended that all voice messaging
ports be placed in their own SFC. The following Service Feature Indexes (SFIs)
are needed in the SFC:
5 Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group (see command ASHU).
6 Complete programming the phone system. See “To complete programming
the phone system” on page 157.
To complete programming the phone system
1 Program each phone to forward calls to the UCD pilot number assigned to
the voice messaging system ports, based on the UM8500 call transfer type:
Release to switch transfer. Program the phone to forward calls to the
UCD pilot number when:
■ The extension is busy;
or,
■ The call is not answered.
Supervised transfer. Program the phone to forward calls to the UCD pilot
number only when the call is not answered. Confirm that call forwarding is
disabled when the extension is busy.
2 Set up the RS-232 serial data port for AIOC settings as follows:
■ 9600 baud
■ 8 data bits
■ 1 stop bit
■ No parity
3 If a remote maintenance modem is used, program the modem line for data
line security.
4 Use the AUCD command to program the phone system to send UCD call
information to MCI. Assign a value of
0 to the MCI Data Transfer field for
the appropriate tenant and UCD pilot numbers.
5 Use the programming system data table to program the ASYD settings. Each
bit is part of a hexadecimal number displayed in the ASYD settings. Convert
the hexadecimal number to binary to determine the individual settings.
SFI Service feature
10 Call hold
103 Assignment of no answer timer for blind transfer
to station or blind transfer to attendant
104 Blind transfer
NOTES
● Logical numbers appear only in a NEC Fusion network and are used
to uniquely identify all the extensions in the network.
● If the phone system that hosts the voice messaging ports extensions
is part of a NEC Fusion network and those ports need to be accessible
from the other Fusion nodes, then the UCD must be configured to
contain the logical numbers corresponding with the ports extensions,
see the commands ALGSN, ASHUN.
CAUTION
Do not use a phantom single line extension for the UCD pilot
number.