Installation guide

Installation

5 41-001525-00 REV00 – 10.2014

Attaching the Stand

1. Locate the stand insertion area on the back of the M685i Expansion Module.

2. Carefully insert the stand into the insertion area and slide the stand towards the right until it snaps in place.

Note:

The orientation of the stand determines the viewing angle. If the bottom of the stand is installed facing the top of the module the

viewing angle will be 35°. If the bottom of the stand is installed facing the bottom of the module the viewing angle will be 55°. The

orientation of the module’s stand must match the orientation of the phone’s stand.

3. Turn over both units so that they are sitting face up on the desk with the M685i Expansion Module sitting flush against the right

side of the phone.

A B

35°

55°