Installation guide

Administrator Level Options
41-001561-00 REV00 – 10.2014 3-31
SIP Settings
The following paragraphs describe the SIP parameters you can configure on the IP phone. SIP configuration consists of
configuring:
• Basic SIP Authentication Settings
• Basic SIP Network Settings
• Advanced SIP settings
• RTP Settings
• Autodial Settings
SIP Priority
RTP Priority
RTCP Priority
SIP Priority
RTP Priority
RTCP Priority
tos priority map This parameter is based on the Type of Service (ToS), Differen-
tiated Services Code Point (DSCP) setting for SIP (tos sip param-
eter), RTP (tos rtp parameter) and RTCP (tos rtcp parameter). It
is the mapping between the DSCP value and the VLAN priority
va l u e f o r S I P, R T P, a n d R TC P p a c k e t s.
You enter the tos priority map value as follows:
(DSCP_1,Priority_1)(DSCP_2,Priority_2).....(DSCP_64,Priority_6
4)
where the DSCP value range is 0-63 and the priority range is 0-
7. Mappings not enclosed in parentheses and separated with a
comma, or with values outside the ranges, are ignored.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-36.
PC Port Settings (Port 1)
PC Port VLAN ID VLAN ID vlan id port 1 Allows you to configure a VLAN ID that associates with the
physical Ethernet Port 1 (PC port).
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-36.
PC Port Priority Priority qos eth port 1 priority Specifies the priority value used for passing VLAN packets
through to a PC via Port 1.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-36.
Notes:
• Specific parameters are configurable on a global and per-line basis. You can also configure specific parameters using
the IP Phone UI, the Mitel Web UI, or the configuration files. If you have a proxy server or have a SIP registrar present
at a different location than the PBX server, the SIP parameters may need to be changed.
• Global SIP settings are applicable to the lines that have a dedicated Line hard key on the phone (e.g. for the 6800i
series IP phones, Line 1 and Line 2). To configure lines that do not have an associated Line hard key (e.g. Line 3
through Line 9), Administrators must configure each individual line manually.
• The IP phones allow you to define different SIP lines with the same account information (i.e., same user name) but
with different registrar and proxy IP addresses. This feature works with Registration, Subscription, and Notify process-
ing. This feature also works with the following types of calls: incoming, outgoing, BroadSoft Shared Call Appearance
(SCA), Bridged Line Appearance (BLA), conference, transfer, blind transfer.
Parameter In
IP Phone UI
Parameter in
Mitel Web UI
Parameters in Configuration
Files
Description