Installation guide

Administrator Level Options
3-24 41-001561-00 REV00 – 10.2014
Custom Ringtones
The IP phones support up to eight custom ringtones. Administrators can install ringtones on the phone using the config-
uration files or the Web UI and users can then simply select a ringtone on the phone to use as their incoming call ringtone.
Reference
For more information about custom ring tones, see Custom Ring Tones on page 5-89.
Network Settings
The following paragraphs describe the network parameters you can configure on the IP phone. Network settings are in
two categories:
• Basic network settings
• Advanced network settings
Notification When Incorrect Network Settings Entered
If an Administrator enters incorrect network settings over the IP Phone UI or the Mitel Web UI, such as:
• A 0.0.0.0 entered as values for the IP Address, Subnet Mask, and Gateway parameters,
• IP Address and Gateway IP address parameter values entered exactly the same,
• Gateway IP address and the IP address parameter values configured not on the same subnet,
the UI will immediately notify the Administrator with a specific message that an incorrect value was entered.
Basic Network Settings
If Dynamic Host Configuration Protocol (DHCP) is enabled, the IP phone automatically configures all of the Network set-
tings. If the phone cannot populate the Network settings, or if DHCP is disabled, you can set the Network options manu-
ally.
Note:
Specific parameters are configurable using the Mitel Web UI only and are indicated where applicable.
Parameter In
IP Phone UI
Parameter in
Mitel Web UI
Parameters in Configuration
Files
Description
DHCP DHCP dhcp Enables or disables DHCP. Enabling DHCP populates the
required network information. The DHCP server serves the
network information that the IP phone requires. If the IP phone
is unable to get any required information, then you must enter
it manually. DHCP populates the following network informa-
tion:
IP Address, Subnet Mask, Gateway, Domain Name System
(DNS) servers, TFTP, HTTP HTTPS, and FTP servers, and Timer
servers.
Note:
For DHCP to automatically populate the IP address or qualified
domain name for the TFTP server, your DHCP server must sup-
port Option 66. The IP phones also support Option 60 and 43.
For more information, see “DHCP” on page4-3.
IP Address IP Address ip IP address of the IP phone. To assign a static IP address, disable
DHCP.
For more information, see “Configuring Network Settings
Manually” on page4-18.