Installation guide

Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters
41-001561-00 REV00 – 10.2014 A-217
Description (continued) When a key is configured for BLF/List functionality, this parameter controls the ring tone
per key. The following ring tones are available:
• Ring tone 1
• Ring tone 2
• Ring tone 3
• Ring tone 4
• Ring tone 5
• Ring tone 6
• Ring tone 7
• Ring tone 8
• Ring tone 9
• Ring tone 10
• Ring tone 11
• Ring tone 12
• Ring tone 13
• Ring tone 14
• Ring tone 15
• Silence (ring tone off)
Note:
Ring tones are based on the current ring tone set configured on the IP phone.
Format Integer
Default Value For BLF For BLF/List
0 (Silence) 100 (Ring tone 1)
Range For BLF For BLF/List
0-6 100 (Ring tone 1)
0 (Silence) 101 (Ring tone 2)
1 (Normal) 102 (Ring tone 3)
2 (Normal delayed) 103 (Ring tone 4)
3 (Periodic) 104 (Ring tone 5)
4 (Periodic delayed) 105 (Ring tone 6)
5 (Low volume) 106 (Ring tone 7)
6 (Low volume delayed) 107 (Ring tone 8)
7 (The behavior is determined by the global 108 (Ring tone 9)
parameter “play a ring splash”. 109 (Ring tone 10)
– If “play a ring splash” is defined as 0 then 110 (Ring tone 11)
the feature is disabled. 111 (Ring tone 12)
– If “play a ring splash” is defined as 1 then 112 (Ring tone 13)
the behavior is the same as Normal. 113 (Ring tone 14)
– If “play a ring splash” is defined as 2 then 114 (Ring tone 14)
the behavior is the same as Normal but the 115 (Silence)
ring splash plays when idle and also during
the active call state).
8 (In call delayed)
9 (In call periodic)
10 (In call periodic delayed)
11 (In call low volume)
12 (In call low volume delayed)
Example For BLF:
hardkey1 ring splash: 1
For BLF/List:
hardkey1 ring splash: 101