Installation guide

Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters
41-001561-00 REV00 – 10.2014 A-207
Ring Splash Settings
Parameter–
keys noname hidden
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description If this parameter is set to “0” (disabled) then a series of question marks (or the symbol config-
ured as defined by the “keys noname symbol” parameter) will be displayed on the screen
indicating blank BLF/List softkeys.
If this parameter is set to “1” (enabled) then the series of question marks (or the symbol con-
figured as defined by the “keys noname symbol” parameter) will be hidden and nothing will
be shown on the screen beside the affected softkeys.
Format Boolean
Default value 0
Range 0-1
0 (disabled)
1 (enabled)
Example keys noname hidden: 1
Parameter –
play a ring splash
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Enables or disables the playing of a short ring splash when there is an incoming call on
a BLF-monitored extension.
Format Integer
Default Value 0 (Disabled)
Range 0 - 2
0 (Disabled)
1 (Enabled for idle state only)
2 (Enabled for idle state and active call state)
Notes:
• This global parameter is not dynamic. Changes to this parameter will take effect only
after the phone has been rebooted.
• Playing a BLF ring splash while in an active call state (i.e. defining the parameter as
“2”) is only available to the 6865i, 6867i, and 6869i IP phones.
Example play a ring splash: 2