Installation guide

Operational, Basic, and Advanced Parameters
A-138 41-001561-00 REV00 – 10.2014
Ring Tone via Speaker During Active Calls Settings
No Service Congestion Tone Settings
Status Code on Ignoring Incoming Calls
Parameter –
ring audibly enable
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Enables/disables the feature whereby the ring tone of an incoming call is played through
the IP phone’s speaker if a user is on an active call or in the process of dialing out.
Notes:
• Feature compatibility is dependant on the IP phone model (see Ring Tone via Speaker
During Active Calls on page 5-90 for more information).
• This feature is not supported when utilizing the headset audio mode.
• With this feature enabled and when the phone’s speaker is playing the incoming call’s
ring tone, call-waiting tones will not be played.
Format Boolean
Default Value 0 (disabled)
Range 0-1
0 (disabled)
1 (enabled)
Example ring audibly enable: 1
Parameter –
no service congestion tone
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description If enabled, the congestion tone will replace the conventional dial tone when the handset
is off hook, a headset is employed, or the speakerphone is engaged. The congestion tone
is played on a per line basis whereby only the specific lines that are without service are
affected.
Format Boolean
Default Value 0 (disabled)
Range 0-1
0 (disabled)
1 (enabled)
Example no service congestion tone: 1
Parameter –
sip ignore status code
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies the status code that is sent in the response to the server when a user ignores
an incoming call.
Format Integer
Default Value 486
Range Valid SIP final negative response code (Refer to RFC3261)
Example sip ignore status code: 486