Installation guide

Administrator Level Options
3-6 41-001561-00 REV00 – 10.2014
Configuration File Options
An Administrator can enter specific parameters in the configuration files to configure the IP phones. All parameters in
configuration files can only be set by an administrator.
References
For a procedure on using the configuration files, see Chapter 2, the section, “Configuration Files (Administrator Only)” on
page2-1.
For a description of each parameter you can enter in the configuration files, see AppendixA, “Configuration Parameters.”
Phone Status
The Phone Status on the IP Phone displays the network status and firmware version of the IP phone.
You can display phone status using the IP phone UI or the Mitel Web UI.
Phone Status via IP Phone UI
In the IP phone UI, the Phone Status options are available to the user and the administrator and do not require a pass-
word entry.
Phone Status for 6863i and 6865i IP Phones
• IP&MAC Addresses
– Displays the IP address and MAC address of the phone.
• LAN Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its LAN port.
• PC Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its PC Port.
• Firmware Info
– Displays information about the firmware and boot version that is currently installed on the IP phone.
• Error Messages
– Displays any error messages that occurred during the phone’s last reboot.