Installation guide
Administrator Level Options
41-001561-00 REV00 – 10.2014 3-5
The following are options that an Administrator can configure in the Mitel Web UI (and are not available for the User to
configure):
• Operation->Reset
– Restore to Factory Defaults
– Remove Local Configuration Settings
• Basic Settings->Preferences->General
– Local Dial Plan
– Send Dial Plan Terminator
– Digit Timeout (seconds)
• Basic Settings->Preferences->Outgoing Intercom Settings (User can configure this via the Mitel Web UI if enabled
by an Administrator)
• Basic Settings->Preferences->Key Mapping
• Basic Settings->Preferences->Priority Alerting Settings
• Basic Settings->Preferences->Directed Call Pickup Settings
• Basic Settings->Preferences->Auto Call Distribution Settings
• Basic Settings->Preferences->Language Settings
– Language 1 (entering language pack filename)
– Language 2 (entering language pack filename)
– Language 3 (entering language pack filename)
– Language 4 (entering language pack filename)
• Basic Settings->Custom Ringtones (User can configure this via the Mitel Web UI if enabled by an Administrator)
• Advanced Settings
– Network
– Global SIP
– Line 1 through 9 Settings
– Action URI
– Configuration Server
– Firmware Update
– TLS Support
– 802.1x Support
– Troubleshooting
References
For information about options available to a User AND Administrator in the Mitel Web UI, see your <Model-Specific> IP
Phone User Guide.
For procedures to Restart your phone or restore factory defaults, see “Restarting Your Phone” on page3-9, and “Set Phone
to Factory Defaults/Erase Local Configuration” on page3-10.
For more information about Advanced Settings for the IP Phone, see Chapter 4, “Configuring Network and Session Initia-
tion Protocol (SIP) Features.”
For procedures on configuring the Basic Settings for the IP Phone, see Chapter 5, “Configuring Operational Features.”