Installation guide
Troubleshooting
9-8 41-001561-00 REV00 – 10.2014
Enabling/Disabling WatchDog
Use the following procedure to enable/disable the WatchDog.
Use the following procedure to enable/disable the WatchDog task for the IP Phones using the Mitel Web UI. You can also
view the “Crash Log” generated by the WatchDog task using the Mitel Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “WatchDog Settings” on pageA-242.
Mitel Web UI
1. Click on Advanced Settings->Troubleshooting.
Enable/Disable WatchDog Task
2. The “WatchDog” field is enabled by default. To disable the WatchDog task, click in the “Enabled” box to clear the check mark.
3. Click Save Settings to save your changes.