Installation guide

Upgrading the Firmware
41-001561-00 REV00 – 10.2014 8-3
Use the following procedure to manually update the firmware on your phone from the specified configuration server.
Mitel Web UI
1. Click on Advanced Settings->Firmware Update.
2. In the “File Name” field, enter the firmware file name (<phone model>.st) that you want to download to your IP phone. For example, 6867i.st
(for a 6867i phone).
Note:
This file name must match the actual name of the firmware file residing on your configuration server.
IMPORTANT: The phones use the following naming convention for the .st files. See the following table.
3. In the “Download Protocol” field, select the protocol from the list to use for downloading the new firmware. Valid values are:
• TFTP
• FTP
• HTTP
• HTTPS
4. In the “Server” field, enter the IP address in dotted decimal format, of the TFTP configuration server, or the domain name of the FTP, HTTP,
or HTTPS configuration servers (dependant on the protocol you selected in step 3.) For example: 432.221.45.6.
5. In the “Path” field, enter the path location on the protocol server for where the new firmware resides. For example, C:\aastra\config-
server\firmwareupgrade.
6. In the “Port” field, enter the port number of the protocol server. For example, 80 (for HTTP) or 443 (for HTTPS).
Note:
This field is not applicable to the TFTP and FTP protocols.
7. (FTP only) In the “Username” field, enter the username that is used for authentication when the FTP server is accessed.
8. (FTP only) In the “Password” field, enter the password that is used for authentication when the FTP server is accessed.
9. Click Download Firmware.
This starts the upgrade process. If the upgrade is successful the following message displays on the screen: "Firmware Upgrade Successful".
IP Phone Model Associated Firmware
6863i 6863i.st
6865i 6865i.st
6867i 6867i.st
6869i 6869i.st