Installation guide

Operational Features
5-231 41-001561-00 REV00 – 10.2014
mode by configuring the new “confxfer live dial” parameter. In live dial mode, when the user is completing a confer-
ence call or transfer, they will hear a dial tone before dialing begins. In addition, the phone will either match the number
to the dial plan or wait for the set digit timeout.
In the default pre-dial mode, users are able to edit the destination number prior to dialing, whereas in live dial mode
they are not able to, however the “Dial” and “Cancel” softkeys are provided while the user inputs the number.
Reference
For more information about conference/transfer support for live dial mode, see your < Model-Specific> SIP IP Phone
User Guide.
Configuring Conference/Transfer in Live Dial Mode
You use the following parameters to configure conference/transfer feature in live dial mode:
• confxfer live dial
Authentication Support for HTTP/HTTPS Download Methods, used with
BroadSoft Client Management System (CMS)
The IP phones support HTTP/HTTPS digest authentication as defined in RFC 2617. (The HTTP client supports digest
authentication; the HTTP server does not; the HTTP server supports basic authentication). This feature allows the phones
to interoperate with BroadSoft’s CMS phone configuration tool.
Using the configuration files, you can enable/disable the following parameter to display a LOG IN softkey which allows
the HTTP/HTTPS server to perform digest authentication:
• http digest force login - specifies whether or not to display the LOG IN softkey on the IP Phone UI screen. Valid values
are 0 (disabled) or 1 (enabled). Default is 0 (disabled).
If the “http digest force login” parameter is set to 1 (enabled), after the phone boots, the LOG IN softkey displays on the
phone’s LCD. If the user presses this softkey, a username/password screen displays, allowing the user to enter the config-
ured username and password that is sent to the HTTP/HTTPS server for digest authentication by the server. By default,
username is “aastra” and password is “aastra”. You can enter the username and password in two ways:
• Using the configuration files, you can change the default values for the following parameters:
– http digest username - specifies the username to use for HTTP/HTTPS digest authentication.
– http digest password - specifies the password to use for HTTP/HTTPS digest authentication.
• By enabling the “http digest force login” parameter (setting to 1) - the phone displays the LOG IN key so the user can
enter the default username/password via the IP Phone UI.
Configuring BroadSoft CMS Support via the Configuration Files
Configure BroadSoft CMS support on the IP Phone using the following parameters in the configuration files:
• http digest force login
• http digest username
• http digest password
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Conference/Transfer in Live Dial Mode” on pageA-78.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “HTTP/HTTPS Authentication Support for BroadSoft CMS”
on pageA-79.