Installation guide

Operational Features
5-193 41-001561-00 REV00 – 10.2014
Configuring Interoperability with an LDAP Directory
Use the following parameters to configure interoperability with an LDAP Directory.
General Directory Options
Enabling/Disabling the Directory
You can enable and disable user access to the Directory List on the IP phones by defining “directory disabled” parame-
ter in the configuration files. Valid values for this parameter are 0 (enabled) and 1 (disabled). If this parameter is set to 0,
the Directory List can be accessed by all users. If this parameter is set to 1, the Directory List does not display on the IP
phone and the Directory key is disabled.
Enabling/Disabling the Directory Using the Configuration Files
Use the following procedures to enable/disable the Directory List on the IP phones.
Display and Sorting
Administrators and users can configure the directory entries to display using the contact’s first name and then last name
or vice versa. Moreover, the option to sort contact’s using either their first name or last name is available. These setings
can be configured by defining the “directory display name order” and “directory sort preference” parameters in the
configuration files or by navigating to the Directory options menu on the 6863i and 6865i, or the Directory > Settings
options menu on the 6867i and 6869i.
Configuring Directory Display and Sorting Options Using the Configuration Files
Use the following parameters to
to configure display and sorting options for the Directory .
ldap other phone attribute
list
Specifies the LDAP other phone (e.g. 1-416-468-3269) for the attribute list. If this parameter contains more than one
value, only the first matching value will be selected in the record.
ldap business fax attribute
list
Specifies the LDAP business fax (e.g. 1-905-760-4233) for the attribute list. If this parameter contains more than one value,
only the first matching value will be selected in the record.
ldap email 1 attribute list Specifies the LDAP email 1 (e.g. [e-mail]) for the attribute list. If this parameter contains more than one value,
only the first matching value will be selected in the record.
ldap email 2 attribute list Specifies the LDAP email 2(e.g. [e-mail]) for the attribute list. If this parameter contains more than one value,
only the first matching value will be selected in the record.
ldap email 3 attribute list Specifies the LDAP email 3 (e.g. [e-mail]) for the attribute list. If this parameter contains more than one value,
only the first matching value will be selected in the record.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, “Basic LDAP Settings” on pageA-112 and “Advanced LDAP Settings” on
pageA-115
Configuration Files
For specific parameters you can set in the configuration files for enabling/disabling the Directory List, see Appendix A, the section, “Enhanced Direc-
tory Settings” on pageA-104.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “General Directory Settings” on pageA-123.
Parameter Description