Installation guide
Operational Features
41-001561-00 REV00 – 10.2014 5-162
9. In the "Type" field, select Pickup.
10. In the "Label" field, enter a label for the Pickup softkey.
Note:
The” Value” and “Line” fields are already configured from the “Park Pickup Config” field.
11. The pickup softkey has a default state of “Idle” and “Outgoing”.
Leave these states enabled or to disable, uncheck the check boxes.
12. Click Save Settings to save your changes.
13. Click on Reset, then click Restart to restart the IP phone and apply the changes.
For the 6863i/6865i:
1. Click on Advanced Settings -> Line 1 (you can select any line)
2. Under Advanced SIP Settings in the “Park Pickup Config” field, enter the appropriate value based on the server in your network.
Notes:
• For values to enter in this field, see the table “Park/Pickup Call Server Configuration Values” on page5-161.
• Leave the park/pickup configuration field blank to disable the park and pickup feature.
3. Click on Operation->Programmable Keys.
4. Pick a key to configure for parking a call.
5. In the "Type" field, select Park.
Note:
The” Value” and “Line” fields are already configured from the “Park Pickup Config” field.
6. Pick a key to configure for picking up a call.
7. In the "Type" field, select Pickup.
Note:
The” Value” and “Line” fields are already configured from the “Park Pickup Config” field.
8. Click Save Settings to save your changes.
9. Click on Operation->Reset.
10. Click on Reset, then click Restart to restart the IP phone and apply the changes.
Mitel Web UI