Installation guide
Operational Features
5-161 41-001561-00 REV00 – 10.2014
Configuring a Park/Pickup Key Using Mitel Web UI
For all phones you first configure the park and pickup keys at Advanced Settings -> Line 1-N by entering the appropri-
ate value based on the server in your network.
For the 6867i and 6869i IP phones, you can enter a key label and change the sofkey states at Operation->Softkeys and
XML. The default state of the park configuration is "connected". The default state of the Pickup configuration is "idle,
outgoing". On the 6863i and 6865i IP phones, you can enter a key label at Operation->Softkeys and XML.
Park/Pickup Call Server Configuration Values
Use the following procedure to configure the park/pickup call feature using the Mitel Web UI.
Note:
Applicable values depend on the server in your network (Asterisk, BroadWorks, Sylantro, ININ). See the table below for
applicable values.
Server Park Values* Pickup Values*
Asterisk 70 70
Sylantro *98 *99
BroadWorks *68 *88
ININ PBX callpark pickup
Mitel Web UI
For the 6867i/6869i:
1. Click on Advanced Settings ->Line 1 (you can select any line)
2. Under Advanced SIP Settings in the “Park Pickup Config” field, enter the appropriate value based on the server in your network.
Notes:
• For values to enter in this field, see the table “Park/Pickup Call Server Configuration Values” on page5-161.
• Leave the park/pickup configuration field blank to disable the park and pickup feature.
3. Click on Operation->Softkeys and XML.
4. Pick a softkey to configure for parking a call.
5. In the "Type" field, select Park.
6. In the "Label" field, enter a label for the park softkey.
Note:
The” Value” and “Line” fields are already configured from the “Park Pickup Config” field.
7. The park softkey has a default state of “Connected”.
Leave this state enabled or to disable, uncheck the check box.
8. Pick a softkey to configure for Picking up a call.