Installation guide
Operational Features
41-001561-00 REV00 – 10.2014 5-142
In the above example, softkey 1 is configured for DND for line 1 only, with a “custom” configuration. Pressing softkey 1 dis-
plays DND screens for which you can customize on the phone.
Configuring DND Using the Mitel Web UI
Use the following procedure to configure DND mode using the Mitel Web UI:
Configuration Files
To set DND in the configuration files, see Appendix A, the sections:
• “DND Key Mode Settings” on pageA-144.
• “Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters” on pageA-174.
Mitel Web UI
1. Click on Basic Settings->Preferences->General.
2. In the “DND Key Mode” field, select a “do not disturb” (DND) mode to use on the phone.
Valid values are: Account, Phone, Custom. Default is Phone.
• Account Sets DND for a specific account. DND key toggles the account in focus on the
IP Phone UI, to ON or OFF.
• Phone Sets DND ON for all accounts on the phone. DND key toggles all accounts on the
phone to ON or OFF.
• Custom Sets the phone to display custom screens after pressing the DND key, that list the
account(s) on the phone. The user can select a specific account for DND, turn
DND ON for all accounts, or turn DND OFF for all accounts.
Notes:
• If there is only one account configured on the phone, then the mode setting is ignored and the phone behaves as if the mode was set to
“Phone”.
• Using the Mitel Web UI, if you change the DND Key Mode to “phone”, all accounts synchronize to the current setting of Account 1.
3. Click Save Settings to save your changes.
The change takes effect immediately without a reboot.