Manualshelf

Installation guide

ManualsBrandsMitel ManualsComputer equipment6800i Series
281282283284285286287288289290
Operational Features
5-99 41-001561-00 REV00 – 10.2014
Configuring BLF/BLF List for Directed Call Pickup
Use the following procedure to configure BLF/BLF List for Directed Call Pickup in the configuration files.
Use the following procedure to configure BLF or BLF/List for Directed Call Pickup in the Mitel Web UI.
4. Enable the "Play a Ring Splash" feature by selecting either Enabled (when idle) or Enabled also in call (when idle and in an active call state.
(Default is disabled).
If the "Play a Ring Splash" parameter is enabled, the IP phone plays a short "ring splash" when there is an incoming call on the BLF moni-
tored extension.
Note:
This global setting is not dynamic. Changes to this setting will take effect only after the phone has been rebooted.
5. Click Save Settings to save your changes.
Note:
You must enable Directed Call Pickup before performing these procedures. See “Enabling/Disabling Directed Call
Pickup” on page5-98.
Configuration Files
To set BLF or BLF/List in the configuration files for Directed Call Pickup, see Appendix A, the sections:
• “Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters” on pageA-174.
• “BLF List URI Settings” on pageA-205.
Mitel Web UI
1. Click on Basic Settings->Preferences->Directed Call Pickup Settings.
2. Enable the "Directed Call Pickup" field by checking the check box.
3. (optional) Enter a prefix in the "Directed Call Pickup Prefix" field. For example, *98.
This prefix is appended to the beginning of the Directed Call Pickup number when dialed from the BLF or BLF/List softkey.
4. Enable the "Play a Ring Splash" feature by selecting either Enabled (when idle) or Enabled also in call (when idle and in an active call state.
(Default is disabled).
If the "Play a Ring Splash" parameter is enabled, the IP phone plays a short "ring splash" when there is an incoming call on the BLF moni-
tored extension.
Note:
This global setting is not dynamic. Changes to this setting will take effect only after the phone has been rebooted.
Mitel Web UI