Installation guide
Operational Features
41-001561-00 REV00 – 10.2014 5-90
Configuring the Custom Ring Tone Feature
Use the following procedures to configure the custom ring tone feature:
Installing a Custom Ring Tone Using the Mitel Web UI
Use the following procedure to install custom ring tones using the Mitel Web UI:
Ring Tone via Speaker During Active Calls
The parameter “ring audibly enable” can be used to configure the IP phones to play the ring tone of an incoming call via
the phone’s speaker while in an active call or if a user is in the process of dialing out.
With the parameter enabled, if a user is in an active call on an extension, and the phone receives a call for the same or dif-
ferent extension, the incoming call will be represented by the call’s ring tone being played through the speaker as well as
the respective line’s LED flashing. This is also the case if a user is in the process of dialing out to a remote number and the
phone receives a call for any line other than the line that is being used to dial out. When the phone exits the ringing state
(e.g. the incoming call is answered), the tone device of the phone will revert back to originally configured audio device.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Custom Ring Tone Settings” on pageA-137.
Mitel Web UI
1. Click on Basic Settings->Custom Ringtones.
2. Press the Browse... button corresponding to the desired ring tone position (e.g. 1).
3. Navigate to the folder containing the WAV file you want to upload, select the file using your left mouse button, and press the Open button.
The filename should now be displayed to the right of the respective Browse... button.
4. Press the Upload button to upload the file to the phone.
5. Repeat Steps 2 to 4 to upload additional WAV files to the phone.
Note:
Press the Delete button to delete the desired ring tone from your phone.
Notes:
• The “ring audibly enable” parameter is disabled by default.
• This feature is not supported when utilizing the headset audio mode.
• With this feature enabled and when the phone’s speaker is playing the incoming call’s ring tone, call-waiting tones
will not be played.