Installation guide
Operational Features
5-83 41-001561-00 REV00 – 10.2014
Enabling/Disabling Redial, Xfer, and Conf Keys
You can enable or disable the Redial, Xfer, and Conf keys as required using the following parameters in the configura-
tion files:
• redial disabled
• conference disabled
• call transfer disabled
Valid values for this parameter are 0 (enabled) and 1 (disabled).
If this parameter is set to 1, the key is not active and is ignored if pressed by the user. For "redial disabled" the value of 1
does not save the dialed number to the "Redial List".
If this parameter is set to 0, the key is active and can be pressed by the user.
This feature is configurable via the configuration files only.
Use the following procedure to enable/disable the Redial, Xfer, and Conf keys.
Mapping Redial and Conf Keys as Speeddials
You can map the Redial and Conference keys on the IP phone to use as Speeddial keys. When the Redial or Conference
key is pressed, the number configured for the key automatically speeddials. If no number is configured, the Redial and
Conference keys return to their original functionality.
You can configure this feature using the configuration files or the Mitel Web UI.
Use the following procedures to set the Redial and Conf keys as Speeddial keys.
Using Redial Key for “Last Number Redial”
The IP phones have an enhanced redial user interface that allows a user to quickly redial the last number that was dialed
out from the phone. You can:
• Press the Redial key twice to redial the last number dialed.
• Press the Redial key once, scroll the list of numbers, then press the Redial button again to dial the number that dis-
plays on the screen.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Mapping Key Settings” on pageA-170.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Mapping Key Settings” on pageA-170.
Mitel Web UI
1. Click on Basic Settings->Preferences.
2. In the Key Mapping section, enter a number in the "Map Redial Key To" field, that the IP phone will use to speeddial when the Redial key
is pressed.
3. Enter a number in the "Map Conf Key To" field, that the IP phone will use to speeddial when the Conf Key is pressed.
4. Click Save Settings to save your changes.