Installation guide

Operational Features

41-001561-00 REV00 – 10.2014 5-76

Configuring LLDP-MED and ELIN

Use the following procedures to configure LLDP-MED and ELIN on the IP phones.

Use the following procedure to enable/disable LLDP-MED using the IP Phone UI.

Configuration Files

For specific parameters you can set in the configuration files, see Appendix A, the section, “LLDP-MED and ELIN Settings” on pageA-127.

Note:

You cannot configure the “LLDP Interval” or the “Use LLDP ELIN” parameters via the IP Phone UI.

IP Phone UI

For the 6863i/6865i:

Press on the phone to enter the Options List.

2. Select Administrator Menu.

3. Select Network Settings.

4. Select Ethernet & VLAN.

5. Select LLDP Support.

6. Press CHANGE to toggle the LLDP setting to Enabled or Disabled.

This field enables or disables Link Layer Discovery Protocol for Media Endpoint Devices (LLDP-MED) on the IP Phone.

7. Press DONE to save the change.

For the 6867i/6869i:

Press to enter the Options List.

2. Press the Advanced softkey.

3. Enter the Administrator password using the keypad. Default is “22222”.

4. Select Network > LLDP.

This option enables or disables Link Layer Discovery Protocol for Media Endpoint Devices (LLDP-MED) on the IP Phone.

Use the

5 and 2 keys enable or disable the feature.

6. Press the Save softkey.