Installation guide

Operational Features
41-001561-00 REV00 – 10.2014 5-30
The amount of time the phone must be idle before the screen saver initiates is configurable through the phones UI or by
defining the “screen save time” parameter in the configuration files.
Configuring the Screen Saver Timer Using the Configuration Files
Use the following parameter to configure the screen saver timer.
Configuring the Screen Saver Timer Using the Phone UI
Use the following procedure to configure the screen saver timer using the IP Phone UI.
Note:
If there are no missed calls, only the date and time are displayed.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Screen Saver Settings” on pageA-55.
IP Phone UI
1.
Press to enter the Options List.
2.
Navigate to the Display option and press the button or Select softkey.
3.
Press the 2
navigation button to highlight the Screen Saver Timer setting.
4. Using the keypad, enter in the desired amount of time (in seconds) the phone must be idle before the screen saver is initiated. The range is
0 (screensaver disabled) to 7200 seconds (with a default of 1800 seconds).
5. Press the Save softkey to save your changes.