Installation guide

Global SIP Settings
4-60 41-001561-00 REV00 – 10.2014
For the 6863i/6865i:
For the 6867i/6869i:
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Select SIP Settings.
Configuring Proxy IP and Proxy Port
4. Select Proxy IP/Port.
5. Enter an IP address or fully qualified host name in the Proxy Server field. Default is 0.0.0.0.
6. Enter a Proxy Port number in the Proxy Port field for accessing the SIP proxy server.
Default is 0.
7. Press Done to save the changes.
Configuring Registrar IP and Registrar Port
8. Select Registrar IP/Port.
9. Enter an IP address or fully qualified host name in the Registrar Server field. Default is 0.0.0.0.
A global value of 0.0.0.0 disables registration. However, the phone is still active and you can dial using username@ip address of the phone.
If the Registrar IP address is set to 0.0.0.0 for a per-line basis (i.e., line 1, line 2, etc.), then the register request is not sent, the "No Service" mes-
sage does not display, and the message waiting indicator (MWI) does not come on.
10. Enter a Registrar Port number in the Registrar Port field for accessing the SIP registrar server.
Default is 0.
11. Press Done to save the changes.
Enabling/Disabling the Use of the Registrar Server
12. Select SIP Register.
13. Press Change to set Register to "Ye s " (enable) or "No" (disable). Default is “Ye s ”.
This parameter enables/disables the IP phone to register on the network.
14. Press Done to save the changes.
Note:
The session prompts you to restart the IP phone to apply the configuration settings.
15. Select Restart.
Note:
You can set global configuration only using the IP Phone UI.
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select SIP > Call Server.