Installation guide

Network Settings
4-40 41-001561-00 REV00 – 10.2014
6. Enter a value for “Type of Service SIP”. D ef a u l t i s 26.
or
Enter a value for “Type of Service RTP”. D ef au lt i s 46.
or
Enter a value for “Type of Service RTCP”. D e f a u l t i s 46.
Valid values are 0 to 63.
Note:
If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map the applicable priority to the Protocol setting
as shown in the first table in “DSCP Range/VLAN Priority Mapping” on page4-38 For more information, see the section “Configuring VLAN
(optional)” on page4-41.
7. Press Done (3 times) to save the changes.
Note:
The session prompts you to restart the IP phone to apply the configuration settings
8. Select Restart.
For the 6867i/6869i:
1.
Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select Network > DSCP.
5. Enter a value for “Type of Service SIP”. D ef a u l t i s 26.
or
Enter a value for “Type of Service RTP”. D ef au lt i s 46.
or
Enter a value for “Type of Service RTCP”. D e f a u l t i s 46.
Valid values are 0 to 63.
Note:
If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map the applicable priority to the Protocol setting
as shown in the first table in “DSCP Range/VLAN Priority Mapping” on page4-38 For more information, see the section “Configuring VLAN
(optional)” on page4-41.
6. Press the Save softkey.
7. Restart the phone for the selection to take affect.
IP Phone UI