Installation guide

Network Settings
41-001561-00 REV00 – 10.2014 4-31
Configuring HTTPS Client and Server Settings
Use the following procedures to configure the HTTPS client and server for the IP phones.
For the 6863i/6865i:
Note:
To enable or disable the IP phones to use the HTTPS protocol as the configuration server, see the section, “Configuring
the Configuration Server Protocol” on page4-80.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “HTTPS Client and Server Settings” on pageA-29.
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Select Configuration Server.
4. Select HTTPS Settings.
Configure HTTPS Client
5. Select HTTPS Client.
6. Select Client Method.
7. Press Change to select a client method to use for HTTPS. Valid values are:
• SSL 3.0 (default)
• TLS 1.0
8. Press Done to save the changes.
Configure HTTPS Server
9. Select HTTPS Server.
10. Select HTTP->HTTPS.
11. Press Change to select “Ye s ” or “No”. D e f a u l t i s “ No”.
Enabling this feature redirects the HTTP protocol to HTTPS.
12. Press Done to save the changes.
13. Select XML HTTP POSTs.
14. Press Change to select “Ye s ” or “No”. D e f a u l t i s “ No”.
Enabling this feature blocks XML HTTP POSTs from the IP Phone.
15. Press Done (4 times) to finish.
Note:
The session prompts you to restart the IP phone to apply the configuration settings.
16. Select Restart.