Installation guide
Network Settings
4-28 41-001561-00 REV00 – 10.2014
Configuring STUN and TURN Servers Using the Configuration Files
Use the following parameters to configure STUN and TURN servers in your network.
• sip stun ip
• sip stun port
• sip turn ip
• sip turn port
• sip turn user
• sip turn pass
Configuring STUN and TURN Servers Using the Mitel Web UI
Use the following procedure to configure STUN and TURN servers in your network using the Mitel Web UI.
Note:
The NAT IP configuration parameter takes precedence over the STUN and TURN parameters.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the sections:
• “SIP STUN Parameters” on pageA-26
• “SIP TURN Parameters” on pageA-27.
Note:
The NAT IP configuration parameter takes precedence over the STUN and TURN parameters.
Mitel Web UI
1. Click on Advanced Settings->Network->Advanced Network Settings.
Configure STUN on the IP Phone