Installation guide

Network Settings
4-26 41-001561-00 REV00 – 10.2014
Configuring SIP and TLS Source Ports Using the Configuration Files
You use the following parameters to configure SIP and TLS ports for NAT traversal:
• sip local port
• sip local tls port
Configuring SIP and TLS Source Ports Using the Mitel Web UI
Use the following procedure to configure SIP and TLS source ports using the Mitel Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the sections:
• “Local SIP UDP/TCP Port Setting” on pageA-25.
• “Local SIP TLS Port” on pageA-26.
Mitel Web UI
1. Click on Advanced Settings->Global SIP->Advanced SIP Settings.
2. The “Local SIP UDP/TCP Port” field has a default value of 5060. Change this value if required to a value greater than 1024 and less than
65535.
Note:
It is recommended that you avoid the conflict RTP port range in case of a UDP transport.