Installation guide

Network Settings
4-24 41-001561-00 REV00 – 10.2014
IP Phone UI
For the 6863i/6865i:
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Select Network Settings.
4. Select Static NAT.
5. Select NAT IP.
6. Enter a public IP address of your NAT device in dotted-decimal format.
7. Press Done to save the setting.
8. Select NAT SIP Port. Default is 51620.
9. Enter the public SIP signaling port number of your NAT device.
10. Press Done to save the setting.
11. Select NAT RTP Port.
12. Enter the RTP Port number of your NAT device. Default is 51720.
13. Press Done (4 times) to finish.
Note:
The session prompts you to restart the IP phone to apply the configuration settings.
14. Select Restart.
For the 6867i/6869i:
Note:
NAT is disabled by default. Use this procedure to enable NAT if required.
1.
Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select Network > NAT.
5. In the NAT IP field, enter the public IP address of your NAT device in dotted-decimal format.
6. In the NAT SIP Port field, enter the public SIP signaling port number of your NAT device. Default is 51620.
7. In the NAT RTP Port field, enter the RTP Port number of your NAT device. Default is 51720.
8. Press the Save softkey.
9. Restart the phone for the selection to take affect.