Installation guide

Network Settings
4-22 41-001561-00 REV00 – 10.2014
Advanced Network Settings
You can set advanced network settings on the IP phone such as, Network Address Translation (NAT), Network Time Pro-
tocol (NTP) Time Servers, Virtual LAN (VLAN), and Quality of Service (QoS) using the Mitel Web UI or the configuration
files.
8. Press the Save softkey.
9. Restart the phone for the selection to take affect.
Mitel Web UI
1. Click on Advanced Settings->Network->Basic Network Settings.
2. In the “LAN Port” field, select a negotiation method to use on port 0. Valid values are:
• Auto Negotiation
• Full Duplex, 10Mbps
• Full Duplex, 100Mbps
• Full Duplex, 1000Mbps (applicable for the 6865i, 6867i, and 6869i IP phones only)
• Half Duplex, 10Mbps
• Half Duplex, 100Mbps
• Half Duplex, 1000Mbps (applicable for the 6865i, 6867i, and 6869i IP phones only)
Default is Auto Negotiation.
3. In the “PC Port” field, select a negotiation method to use on port 1. Valid values are:
• Auto Negotiation
• Full Duplex, 10Mbps
• Full Duplex, 100Mbps
• Full Duplex, 1000Mbps (applicable for the 6865i, 6867i, and 6869i IP phones only)
• Half Duplex, 10Mbps
• Half Duplex, 100Mbps
• Half Duplex, 1000Mbps (applicable for the 6865i, 6867i, and 6869i IP phones only)
Default is Auto Negotiation.
4. Click Save Settings to save your settings.
Note:
The available advanced network parameters via the IP phone UI are NAT, VLAN, and QoS only.
IP Phone UI