Installation guide

Network Settings
41-001561-00 REV00 – 10.2014 4-21
6. Select a negotiation method to use on port 0 and press Done. Valid values are:
• AutoNegotiation
• Full 10Mbps
• Full 100Mbps
• Full 1000Mbps (applicable for the 6865i)
• Half 10Mbps
• Half 100Mbps
• Half 1000Mbps (applicable for the 6865i)
Default is AutoNegotiation.
7. Select PC Port Link.
8. Select a negotiation method to use on port 1and press Done. Valid values are:
• AutoNegotiation
• Full 10Mbps
• Full 100Mbps
• Full 1000Mbps (applicable for the 6865i)
• Half 10Mbps
• Half 100Mbps
• Half 1000Mbps (applicable for the 6865i)
Default is AutoNegotiation.
9. Press Done (3 times) to finish configuring the configuration server protocol for the IP phone.
Note:
The session prompts you to restart the IP phone to apply the configuration settings.
10. Select Restart.
For the 6867i/6869i:
1.
Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select Network > Ethernet Ports.
5. With LAN Port highlighted, press the right navigation key and select a negotiation method to use on port 0. Valid values are:
• AutoNegotiation
• Full 10Mbps
• Full 100Mbps
• Full 1000Mbps
• Half 10Mbps
• Half 100Mbps
• Half 1000Mbps
Default is AutoNegotiation.
6. Press the left navigation key and press down to highlight PC Port.
7. Select a negotiation method to use on port 1. Valid values are:
• AutoNegotiation
• Full 10Mbps
• Full 100Mbps
• Full 1000Mbps
• Half 10Mbps
• Half 100Mbps
• Half 1000Mbps
Default is AutoNegotiation.
IP Phone UI