Installation guide
Network Settings
4-4 41-001561-00 REV00 – 10.2014
Enabling/Disabling DHCP Using the Configuration Files
Use the following procedure to enable/disable DHCP on the phone using the configuration files.
Enabling/Disabling DHCP Using the IP Phone UI
Use the following procedure to enable/disable DHCP on the phone using the IP Phone UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Network Settings” on pageA-7.
IP Phone UI
For the 6863i/6865i:
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Enter your Administrator password.
Note:
The IP Phones accept numeric passwords only.
4. Select Network Settings.
5. Select option DHCP.
6. Press Change to set "Use DHCP?" to "Yes" (enable) or "No" (disable).
7. Press Done to save the changes.
For the 6867i/6869i:
1.
Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select Network > Settings.
5.
In the “Use DHCP?” checkbox, press the button to enable or disable DHCP.
6. Press the Save softkey.
7.
Press the button, the button, or the Quit softkey to return to the idle screen.