Installation guide

Additional Information

Configuring the Play A Ring Splash Setting Using the Mitel Web UI

Use the following procedure in the Mitel Web UI to configure the Play a Ring Splash setting:

1. Click on Basic Settings ->Preferences ->Directed Call Pickup Settings

2. Using the Play a Ring Splash drop-down menu, select the preferred setting. Options

include:

• Disabled

• Enabled

• Enabled also in call

3. Click Save Settings to save your changes.

Configuring BLF and BLF/List Ring Splash Support Using the Configuration Files

Use the following parameters to configure the BLF and BLF/List ring splash feature:

ring splash frequency Indicates the frequency interval (in seconds) when the “...keyN ring

splash” parameter is set to a “periodic” alerting pattern.

ring splash volume Indicates the volume of the ring splash from 1 (loudest) to 9 (softest) when

the “...keyN ring splash” parameter is set to a “low volume” alerting

pattern.

Note: This global setting is not dynamic. Changes to this setting will take effect only

after the phone has been rebooted

PARAMETER

play a ring splash

CONFIGURATION FILES

startup.cfg, <model>.cfg, <mac>.cfg

DESCRIPTION Enables or disables the playing of a short ring splash when there is an

incoming call on a BLF or BLF/List-monitored extension.

FORMAT Integer

DEFAULT VALUE 0 (Disabled)

RANGE 0 - 2

0 (Disabled)

1 (Enabled for idle state only)

2 (Enabled for idle state and active call state)

Note: This global parameter is not dynamic. Changes to this parameter will

take effect only after the phone has been rebooted.

EXAMPLE play a ring splash: 2

PARAMETER DESCRIPTION