Installation guide

6510 UM Server Installation Guide 251
MSS Setup
Understanding the RIMMSS Connector
The RIMMSS connector for Blackberry devices is not a real MSS connector. It
converts SMTP sync messages from the RIM handheld device to the real MSS
synchronization messages and vice versa.
Note: The current version of the RIMMSS connector does not
support custom folders, folders moving, copying, or deleting.
There are three different scenarios for setting up the RIMMSS connector:
1. MSS Server – An MSS Server with logged in clients (for example, e-
mail, voice mail and RIMSS)
2. RIM Server – A particular computer with RIMMSS connector
installed, Usually Voice Server.
3. Server B – A messaging server with MSS connector installed (for
example, Microsoft Exchange or Lotus Notes server)
Configuring the RIMMSS Connector
The MSS Connector performs actions to determine the addresses of the unread
messages counter. Depending on the version of the RIM operating system you are
using, these addresses are assigned different values. 12 libraries have been created
to address each of the known sets of RIM operating systems and their
corresponding message .dlls.
To ensure that the RIMMSS Connector determines the correct addresses of the
unread message counter, you must use the MSSConnector*.dll that matches
with the RIM OS and message .dll versions installed on your Blackberry Wireless
Device. The table below indicates the correct MSSConnector*.dll to use with each
known set of RIM OS and Message .DLL.
Library RIM OS/Message .DLL version
MSSConnector14570_15000.dll RIM OS 1.4.57.0/Message .dll 1.5.000
MSSConnector14890_16030.dll RIM OS 1.4.89.0/Message .dll 1.6.030
MSSConnector2013_17000REL.dll RIM OS 2.0.13/Message .dll 1.7.000 (Release)