User guide
Table Of Contents
- 11BRing/Message indicators
- 12BSelecting Menu Options
- 13BAbout Feature Access Codes
- 14BLine Interface Module
- 15BDon't cradle the handset!
- 16BProtect your hearing
- 17BAdjust the viewing angle
- 18BRinger Control
- 19BHandset Receiver Volume Control
- 20BSpeaker Volume Control
- 21BDisplay Contrast Control
- 22BFeature Keys
- 23BLanguage Change
- 24BMake a Call - PBX
- 25BMake an External Call - KTS
- 26BMake an Intercom Call - KTS
- 27BAnswer a call
- 28BRedial
- 29BSpeed Call Keys
- 30BSpeed Call – Personal
- 31BHandsfree Operation
- 32BAuto–Answer
- 33BGroup Listen
- 34BHold
- 35BHold and Page
- 36BMute
- 37BHandset Mute (does not work?)
- 38BTransfer
- 39BConference
- 40BConference Split (5324 IP Phone only)
- 41BAdd Held (5324 IP Phone only)
- 42BSwap
- 43BCall Forward
- 44BCall Forward - Remote (I am Here)
- 45BCall Forward - Forced
- 46BCall Forward - Toggle
- 47BMessaging - Advisory
- 48BMessaging - Callback
- 49BAccount Codes
- 50BCallback
- 51BCall Park
- 52BCall Park - System
- 53BCall Park - Specific Orbit
- 54BCall Park - Destination Phone
- 55BCall Pickup
- 56BCampon
- 57BDo Not Disturb
- 58BOverride
- 59BPaging - PA
- 60BPaging - Direct
- 61BHandsfree Answerback to a Direct Page
- 62BPaging - All Sets
- 63BPaging - Group
- 64BDirect Station Select/Busy Lamp Field (DSS/BLF)
- 65BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Call Pickup
- 66BDirect Page/Busy Lamp Field (DP/BLF)
- 67BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Direct Page/Call Pickup
- 68BHeadset Operation
- 69BMusic
- 70BPark and Page
- 71BRecord a Call
- 72BAuto-Latch Microphone
- 73BReminder
- 74BReminder - Multiple
- 75BCall Logging (5324 IP Phone only)
- 76BPhonebook
- 77BCall Monitoring
- 78BDoor Opener
- 79BNight Answer
- 80BDate and Time Setup
- 81BRelease
- 82B
- Secure Hot Swap
- 83BMobile Extension
- 84BTurn the conference unit on and off
- 85BAdjust the conference unit volume
- 86BPlace the conference unit in Presentation mode
- Mute the Conference Unit
- Exit the conference
- 89BTo start a Conference
- 90BAdjust the conference unit volume
- 91BMute the conference unit
- 92BExit the conference
- 93BLINE INTERFACE MODULE MODE
- 94BFAILOVER MODE
- 95BEMERGENCY CALLS
- 96BFEATURE ACCESS CODES
5312/5324 IP Phones User Guide
USING YOUR 5324 IP PHONE WITH THE 5310 IP CONFERENCE UNIT
The 5324 IP Phone supports the 5310 Conference Unit. Your phone may use the 5310 IP
Conference Unit for conferencing. An optional mouse connected directly to the conference unit is
used to control the conference unit on or off, to adjust the volume, mute the conference call, or to put
the conference unit into Presentation mode.
If a mouse is not installed, the conference unit acts as the phone’s speaker for all operations, except
ringing. For example, when the SPEAKER key
is pressed during a headset or handset call, the
audio path is directed to the Conference Unit.
The 5324 IP Phone will activate the 5310 Conference Saucer when it detects that the Conference
Module has been installed in the back of the phone.
You can only run one Conference session at a time. If the 5310 Conference Unit is not connected to
your phone, the Conference application is not available.
Using the 5310 Conference Unit with a Mouse
Use the procedures below if you 5310 Conference Unit has a mouse attached.
Turn the conference unit on and off
1. Verify that the conference unit is connected to your phone.
2. Press the Power (On) key on the mouse to turn the unit on.
3. Press the Power key again to turn the conference unit off.
Adjust the conference unit volume
• Press Volume Up or Volume Down key on the mouse.
39