User guide
Table Of Contents
- 11BRing/Message indicators
- 12BSelecting Menu Options
- 13BAbout Feature Access Codes
- 14BLine Interface Module
- 15BDon't cradle the handset!
- 16BProtect your hearing
- 17BAdjust the viewing angle
- 18BRinger Control
- 19BHandset Receiver Volume Control
- 20BSpeaker Volume Control
- 21BDisplay Contrast Control
- 22BFeature Keys
- 23BLanguage Change
- 24BMake a Call - PBX
- 25BMake an External Call - KTS
- 26BMake an Intercom Call - KTS
- 27BAnswer a call
- 28BRedial
- 29BSpeed Call Keys
- 30BSpeed Call – Personal
- 31BHandsfree Operation
- 32BAuto–Answer
- 33BGroup Listen
- 34BHold
- 35BHold and Page
- 36BMute
- 37BHandset Mute (does not work?)
- 38BTransfer
- 39BConference
- 40BConference Split (5324 IP Phone only)
- 41BAdd Held (5324 IP Phone only)
- 42BSwap
- 43BCall Forward
- 44BCall Forward - Remote (I am Here)
- 45BCall Forward - Forced
- 46BCall Forward - Toggle
- 47BMessaging - Advisory
- 48BMessaging - Callback
- 49BAccount Codes
- 50BCallback
- 51BCall Park
- 52BCall Park - System
- 53BCall Park - Specific Orbit
- 54BCall Park - Destination Phone
- 55BCall Pickup
- 56BCampon
- 57BDo Not Disturb
- 58BOverride
- 59BPaging - PA
- 60BPaging - Direct
- 61BHandsfree Answerback to a Direct Page
- 62BPaging - All Sets
- 63BPaging - Group
- 64BDirect Station Select/Busy Lamp Field (DSS/BLF)
- 65BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Call Pickup
- 66BDirect Page/Busy Lamp Field (DP/BLF)
- 67BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Direct Page/Call Pickup
- 68BHeadset Operation
- 69BMusic
- 70BPark and Page
- 71BRecord a Call
- 72BAuto-Latch Microphone
- 73BReminder
- 74BReminder - Multiple
- 75BCall Logging (5324 IP Phone only)
- 76BPhonebook
- 77BCall Monitoring
- 78BDoor Opener
- 79BNight Answer
- 80BDate and Time Setup
- 81BRelease
- 82B
- Secure Hot Swap
- 83BMobile Extension
- 84BTurn the conference unit on and off
- 85BAdjust the conference unit volume
- 86BPlace the conference unit in Presentation mode
- Mute the Conference Unit
- Exit the conference
- 89BTo start a Conference
- 90BAdjust the conference unit volume
- 91BMute the conference unit
- 92BExit the conference
- 93BLINE INTERFACE MODULE MODE
- 94BFAILOVER MODE
- 95BEMERGENCY CALLS
- 96BFEATURE ACCESS CODES

5312/5324 IP Phones User Guide
Night Answer
Office telephone systems are often placed into Night Answer after regular hours. Calls then ring
alternate answer points—either designated extensions or a night bell. You can dial the Trunk Answer
From Any Station (TAFAS) code to answer calls ringing the night bell. If permitted by system
programming, you can put your phone into one of two night answer modes, Night1 or Night2.
To switch your 5312 IP Phone to Night Answer or back to Day service:
1. Lift the handset.
2. Press the Night Answer feature key. (See "Feature Key" for instructions on programming a
feature key.)
3. Do one of the following:
• Press 0 for Day Service.
• Press 1 for Night1.
• Press 2 for Night2.
4. Hang up.
The Night Answer feature key light flashes slowly for Night1, and rapidly for Night2. The Night
Answer feature key light is off for when your phone is in Day service.
To switch your 5324 IP Phone to Night Answer or Day service, or to view which service your 5324 IP
Phone is currently in:
1. Press
( MENU ).
2. Press the No softkey until “Night Answer?" appears.
3. Press the Yes softkey
4. Do one of the following:
• To exit without making any changes, press
(MENU).
• To change the mode of service, press the Change softkey, followed by No until the desired
alternative appears, and then press Yes.
36










