User guide
Table Of Contents
- 11BRing/Message indicators
- 12BSelecting Menu Options
- 13BAbout Feature Access Codes
- 14BLine Interface Module
- 15BDon't cradle the handset!
- 16BProtect your hearing
- 17BAdjust the viewing angle
- 18BRinger Control
- 19BHandset Receiver Volume Control
- 20BSpeaker Volume Control
- 21BDisplay Contrast Control
- 22BFeature Keys
- 23BLanguage Change
- 24BMake a Call - PBX
- 25BMake an External Call - KTS
- 26BMake an Intercom Call - KTS
- 27BAnswer a call
- 28BRedial
- 29BSpeed Call Keys
- 30BSpeed Call – Personal
- 31BHandsfree Operation
- 32BAuto–Answer
- 33BGroup Listen
- 34BHold
- 35BHold and Page
- 36BMute
- 37BHandset Mute (does not work?)
- 38BTransfer
- 39BConference
- 40BConference Split (5324 IP Phone only)
- 41BAdd Held (5324 IP Phone only)
- 42BSwap
- 43BCall Forward
- 44BCall Forward - Remote (I am Here)
- 45BCall Forward - Forced
- 46BCall Forward - Toggle
- 47BMessaging - Advisory
- 48BMessaging - Callback
- 49BAccount Codes
- 50BCallback
- 51BCall Park
- 52BCall Park - System
- 53BCall Park - Specific Orbit
- 54BCall Park - Destination Phone
- 55BCall Pickup
- 56BCampon
- 57BDo Not Disturb
- 58BOverride
- 59BPaging - PA
- 60BPaging - Direct
- 61BHandsfree Answerback to a Direct Page
- 62BPaging - All Sets
- 63BPaging - Group
- 64BDirect Station Select/Busy Lamp Field (DSS/BLF)
- 65BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Call Pickup
- 66BDirect Page/Busy Lamp Field (DP/BLF)
- 67BDirect Station Select (DSS)/Busy Lamp Field (BLF)/Direct Page/Call Pickup
- 68BHeadset Operation
- 69BMusic
- 70BPark and Page
- 71BRecord a Call
- 72BAuto-Latch Microphone
- 73BReminder
- 74BReminder - Multiple
- 75BCall Logging (5324 IP Phone only)
- 76BPhonebook
- 77BCall Monitoring
- 78BDoor Opener
- 79BNight Answer
- 80BDate and Time Setup
- 81BRelease
- 82B
- Secure Hot Swap
- 83BMobile Extension
- 84BTurn the conference unit on and off
- 85BAdjust the conference unit volume
- 86BPlace the conference unit in Presentation mode
- Mute the Conference Unit
- Exit the conference
- 89BTo start a Conference
- 90BAdjust the conference unit volume
- 91BMute the conference unit
- 92BExit the conference
- 93BLINE INTERFACE MODULE MODE
- 94BFAILOVER MODE
- 95BEMERGENCY CALLS
- 96BFEATURE ACCESS CODES

5312/5324 IP Phones User Guide
Reminder - Multiple
Note: The Reminder feature will not operate if Auto-Answer is enabled on your phone.
To set multiple reminders (up to three) on a 5312 IP Phone (only):
1. Lift the handset.
2. Dial *32.
3. Dial # followed by the number of the timer (#1, #2, or #3). To repeat the timer daily, dial *.
4. Set a time by entering the hour and minutes in 24-hour format. For example, entering 1415 sets a
reminder for 2:15 PM.
You hear dial tone if the time is valid; you hear reorder tone if it is invalid.
5. Repeat for each additional timer.
To cancel one or multiple reminders on a 5312 IP Phone (only):
1. Lift the handset.
2. Dial *32.
3. Do one of the following:
• Dial 9999 to cancel Timed Reminder #1
• Dial # followed by the timer number (2 or 3) and 9999 to cancel a reminder other than #1.
4. Replace the handset.
To set multiple reminders (up to three) on a 5324 IP Phone (only):
1. Press
(MENU).
2. Press the No softkey until "Timed Reminder?" appears.
3. Press the Yes softkey.
4. Enter the time for Timer 1 in 12-hour format--for example, 01:45.
5. Press either the AM or PM softkey.
6. Press the Save softkey.
7. Press the Yes or No softkey depending on whether you want the reminder to repeat daily.
8. Repeat the first three steps, and then press the Next softkey to set Timer 2.
9. Repeat the procedure for Timer 3.
To view, change, and/or cancel a pending Reminder:
1. Press
(MENU).
2. Press the No softkey until "Timed Reminder?" appears.
3. Press the Yes softkey.
4. The reminder time for TIMER 1 appears (an asterisk beside the time indicates that the timer
repeats daily, HH:MM indicates that the timer has not been programmed).
5. Press the Next softkey to display the other timers.
6. Do one of the following:
32










