User guide

5312/5324 IP Phones User Guide
You are on a handset call, and
MUTE is flashing slowly
1. Check that MUTE is ON solid.
2. Press MUTE.
The light turns OFF and the Handsfree microphone turns
ON.
3. Speak to the paging party.
Note: Your handset microphone is still enabled.
You are on a MUTED handset
call, OR, you are on a
Handsfree call
The party paging you receives a busy tone.
Handsfree Answerback does not interrupt your call.
To answer a Direct Page when Handsfree Answerback is OFF on your phone, refer to the following
table:
Phone state before the Direct
Page arrives
To answer the Direct Page (indicated by a single burst of tone)
Phone is idle, or you are on a
handset call, and MUTE is OFF
1. Check that MUTE is ON solid.
2. Lift the handset.
or
Press MUTE key to answer in Handsfree mode.
(The light turns OFF.)
3. Begin speaking.
Note: If you were on a handset call, your handset microphone is still
enabled.
1. You are on a MUTED
handset call, OR, you are
on a Handsfree call
The party paging you receives a busy tone.
Handsfree Answerback does not interrupt your call.
To end a Handsfree Answerback call, do one of the following:
• Hang up the handset to end a handset call.
• Press
(SPEAKER) to end a handsfree call.
• Press
(CANCEL).
Note: When the Handsfree Direct Page call ends, the
(MUTE) key light returns to the state it was
in before the call was established.
24