User guide

5312/5324 IP Phones User Guide
To retrieve a parked call while you are on a call on your prime line, do one of the following:
• Press the Call Park feature key.
OR
• Press TRANS/CONF and then dial *22.
You are connected to the parked call and the caller that was on your prime line is parked.
To retrieve a parked call from another phone:
1. Lift the handset.
2. Dial *23.
3. Dial the prime line number (extension number) of the phone that parked the call.
Note: If the phone has both a parked call and a call on hold, dialing the Remote Hold Retrieve access
code will retrieve the parked call.
Call Park - System
This feature allows you to park a call from any line on your telephone not just the prime line. The
number of calls you can park is limited only by the number available system park "orbits."
To park a call in system orbit:
1. Press the lit System Park feature key.
2. Do either of the following:
• Hang up
• Press a line key to answer a call, retrieve a call or hold, or get dialtone.
To return to the caller if all the system orbits are busy:
• Press (CANCEL) to return to the caller.
To retrieve a call parked on a system orbit from any extension:
• While listening to dial tone, dial *57 followed by the park orbit number.
Call Park - Specific Orbit
This feature allows you to park a call in a specific orbit by entering a two digit orbit number or by
pressing a feature key assigned to a specific orbit number.
To park a call in a specific orbit:
1. Press the System Park feature key.
2. Enter a two-digit Orbit Number (01-25).
If the selected orbit already has a parked call, press (CANCEL) to return to the caller, and then repeat
steps 1 and 2 but select a different orbit.
20