Specifications

Using the phone system 9Final
2 Plug the phone into the network.
3 Plug the computer into the phone at the port marked PC.
4 Connect one end of the phone power pack into your phone and the other
end into a power outlet.
Note: If your network is configured with Power Over Ethernet (POE), the
above step is not necessary.
5 Wait for the Information Display Area to show "Logged Out" (this may take
30 seconds or more).
6 Press the ACTIVATE softkey.
The Information Display Area will prompt you for your "Extension:"
7 Enter your extension.
8 If you have login/logout privileges, the Information Display Area will
prompt you for your "PIN:"
Enter your PIN, then press the ENTER softkey.
9 If you do not have login/logout privileges, the Information Area Display will
show your extension
Press the YES softkey.
You have now successfully activated the phone, and can make calls.
See “Quick set-up” on page 120 for information about initial settings you
should configure through the web interface.
Answering a call on the 5320/5330/5340/5260
phone
When an incoming call is received on a phone, several things happen: (1) the
phone rings, (2) a Line Appearance flashes, and (3) the Information Area
Display shows the phone number of the caller and, if known, the name of the
caller.
You can answer an incoming call by picking up the handset, pressing the
flashing Line Appearance key, pressing the ANSWER softkey, or by pressing
the key.
Because the Mitel 5320/5330/5340/5260 IP phone has multiple pages of
programmable memory keys, it is possible that the call could appear on a Line
Appearance key located on a different page from the one being displayed. In
this case, you can still answer the call by picking up the handset, pressing the
ANSWER softkey, or by pressing the key.