Specifications

Mitel IP Phone Reference Guide
22 Using Phones
The verification tone enables you to establish whether the silhouette
cordless is working in the extended area of the repeater. This tone
is audible on the activated silhouette cordless as long as the unit is
connected to the repeater. To toggle the verification tone, follow this
procedure:
A. Switch off the repeater (disconnect the power plug).
B. Switch on the repeater for 1-5 seconds and switch it off again.
C. Switch it on again.
The LED on the unit is flashing slowly, switch it off again.
D. Switch it on again.
The verification tone is then activated or deactivated.
Cordless Registration
After you have physically installed the IP DECT Stand to a Mitel IP Phone, you must
register the handsets with the IP DECT Stand. You can then configure the 5610 cordless
handsets for operation using
• a web browser, such as Internet Explorer (recommended method)
• the menu on the 5610 cordless handset
• a configuration file that you install on a server in the Local Area Network
If you configure from the web browser interface or from the handset, you must configure
each handset individually. If you use configuration files, a file must be created for each
IP DECT Stand. The configuration file specifies the parameters of the handsets (up to
eight) that are associated with an IP DECT Stand.
To complete registration and configuration, the following must be completed:
• "Add Site"
• "Add a User"
• Register the Handsets with the IP DECT Stand
• Assign an IP Address to the IP DECT Stand
• Configure Handsets via IP-DECT Stand Configurator Web Interface
After you configure the handsets on an IP DECT Stand, ensure that you Change
the Handset Display Name and PIN from the default values to prevent unauthorized
access.