User guide

Call Features
Page 36 Mitel
®
5304 IP Phone User Guide – Issue 1, September 2009
Remote Programming
You can use Remote Programming to access the DND, Call Forwarding, and Personal Call
Routing features from another system phone or an external phone.
3
For security reasons,
remote programming requires a password.
Changing Your Remote Programming Password
Your default Remote Programming password is your extension number. Before using Remote
Programming, you should change your default password.
To change your Remote Programming password from your phone:
1. Lift the handset and dial 392. ENTER PASSWORD appears.
2. Enter your current password (the default password is your extension number), followed
by #. CHANGE PASSWORD TO appears.
3. Enter the new password followed by
#. VERIFY PASSWORD appears.
4. Enter the new password again followed by #. DATABASE UPDATED appears.
You can also change your Remote Programming password from another phone.
To change your Remote Programming password from another phone:
1. Do one of the following:
• Call your DISA number (provided by your system administrator). If necessary, enter
your (DISA) password.
• Use any phone on the system.
2. Dial 359.
3. Enter your extension number.
4. Enter your password followed by #.
5. Dial 392.
6. Enter the new password followed by
#.
7. Enter the new password again followed by #.
3. This feature may or may not be enabled for your system.
NOTE
A Direct Inward System Access (DISA) number is required to use Remote
Programming from an external phone. Contact your system administrator for more
information.