User guide

Mitel
®
Model 5212/5224 Endpoint User Guide– Issue 2, October 2008 Page 7
Getting Started
Headset Instructions
When using a headset, press (Speaker) to connect to or disconnect from calls. The
Headset icon appears when the headset is in use. You cannot use the handset or
speakerphone when the endpoint is in Headset Mode. Disconnecting the headset automatically
enables the handset.
To connect and activate the headset:
1. Insert the headset jack into the Headset port located on the back of the endpoint.
2. Dial 317
(Headset on/off). HEADSET MODE ON appears.
To turn off Headset Mode and activate the handset and speakerphone:
Dial 317
(Headset on/off). HEADSET MODE OFF appears.
NOTES
The headset must be hearing aid compatible (HAC).
If your headset has a power-saver mode, make sure the system administrator has
enabled the “Headset Connect Tone” feature. If this is not enabled, you may miss
the first few seconds of an incoming call.
NOTE
Because Headset Mode disables the handset and speakerphone, you
must turn off Headset Mode before you can use the handset or
speakerphone.