User guide
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Programming
- Programming overview
- About the programming tools
- Enable your options
- Programming the system parameters
- Programming the extensions
- Programming the voice parameters
- Modify the extensions and system directory
- Program the terminal emergency numbers (ELINs)
- About the default line numbers
- Program the general line parameters
- Program the analog lines
- Program the digital trunks
- Assign priority lines
- Restrict external access (toll restriction/call barring)
- Program the voice management parameters
- Programming the voice mail settings
- Setting up the auto attendant
- Configuring call logging (SMDR)
- Programming a loudspeaker
- Committing your changes
- Performing a database backup
- Programming tips
- Chapter 4 Configuring the IP network
- About IP networking
- Network capabilities
- Planning your LAN
- IP programming sequence
- Connecting directly to the Internet
- Connecting to the Internet through an existing LAN
- Using a remote DHCP server
- Changing the assigned DHCP IP address range
- Configuring Domain Name Service
- Assigning a gateway
- Programming dial-up access to an ISP
- Configuring NAT Redirect
- Restricting LAN access (firewall)
- IP networking tips
- Chapter 5 Routine maintenance
- Is the system healthy?
- Is the system secure?
- Checking the system
- Launching the tools
- Enabling your licensed options
- Rebooting the system
- Powering down the system
- Powering up the system
- Upgrading the system
- Performing backups
- Saving call (SMDR) logs
- Using a remote access session
- Changing extensions or set types
- Creating a user guide
- Using a database template
- Maintenance tips
- Chapter 6 Troubleshooting and repair
- Checking the system LEDs
- Checking the logs
- Viewing diagnostics
- Using maintenance commands
- Using Windows networking commands
- Line troubleshooting
- IP port troubleshooting
- IP phone troubleshooting
- Analog phone troubleshooting
- System troubleshooting
- Network troubleshooting
- Fixing database or software corruption
- Replacing faulty components
- Troubleshooting tips
- Appendix A Default database
- Appendix B Reference
- Appendix C Planning
- Index
Programming
63
7. Set the Protocol Variant according to the following
table:
8. Click Save.
Configure the trunks
1. Click Trunk Circuit Descriptor Summary. Note the
type of descriptors currently programmed.
2. Click Digital Trunk Circuit Descriptors and then
click the required descriptor form
- Digital E and M Trunk Circuit Descriptor
- Digital CO Trunk Circuit Descriptor
- Digital DID Trunk Circuit Descriptor
- Digital PRI Trunk Circuit Descriptor
These forms allow you to assign signaling and timing
parameters to the trunk circuits.
Note that default descriptors are included with the
system. If you choose to use the defaults, you can
skip to step 6..
3. Click the desired descriptor number, click Change
and modify the fields as required. Click Help for a
description of the fields. Click Save.
Protocol Variant Interface Type
DMS100 Not applicable T1
DMS200 Not applicable T1
4ESS Not applicable T1
NI2 Bellcore T1
5ESS T1
GTD5 T1