User guide
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Programming
- Programming overview
- About the programming tools
- Enable your options
- Programming the system parameters
- Programming the extensions
- Programming the voice parameters
- Modify the extensions and system directory
- Program the terminal emergency numbers (ELINs)
- About the default line numbers
- Program the general line parameters
- Program the analog lines
- Program the digital trunks
- Assign priority lines
- Restrict external access (toll restriction/call barring)
- Program the voice management parameters
- Programming the voice mail settings
- Setting up the auto attendant
- Configuring call logging (SMDR)
- Programming a loudspeaker
- Committing your changes
- Performing a database backup
- Programming tips
- Chapter 4 Configuring the IP network
- About IP networking
- Network capabilities
- Planning your LAN
- IP programming sequence
- Connecting directly to the Internet
- Connecting to the Internet through an existing LAN
- Using a remote DHCP server
- Changing the assigned DHCP IP address range
- Configuring Domain Name Service
- Assigning a gateway
- Programming dial-up access to an ISP
- Configuring NAT Redirect
- Restricting LAN access (firewall)
- IP networking tips
- Chapter 5 Routine maintenance
- Is the system healthy?
- Is the system secure?
- Checking the system
- Launching the tools
- Enabling your licensed options
- Rebooting the system
- Powering down the system
- Powering up the system
- Upgrading the system
- Performing backups
- Saving call (SMDR) logs
- Using a remote access session
- Changing extensions or set types
- Creating a user guide
- Using a database template
- Maintenance tips
- Chapter 6 Troubleshooting and repair
- Checking the system LEDs
- Checking the logs
- Viewing diagnostics
- Using maintenance commands
- Using Windows networking commands
- Line troubleshooting
- IP port troubleshooting
- IP phone troubleshooting
- Analog phone troubleshooting
- System troubleshooting
- Network troubleshooting
- Fixing database or software corruption
- Replacing faulty components
- Troubleshooting tips
- Appendix A Default database
- Appendix B Reference
- Appendix C Planning
- Index
Technician’s Handbook
34
Using the system quick installation tool
Do not close your browser window during the
quick installation wizard. If you do not complete
the wizard, the system configuration will be
invalid. If you accidently close your browser,
restart the quick installation tool and enter your
information again.
You should only use the system quick installation
tool once during initial installation.
Note that the system quick installation tool does
not allow you to program T1 or PRI lines.
1. Review the system defaults; see Default Database
(p. 195).
2. Complete the pre-configuration questionnaire that
was shipped with the system.
3. If you plan to change the number of digits in the
extension numbering plan (for example, from the
default 3-digit extension numbers to 4-digit numbers),
you should set up the voice mailboxes through the
administration mailbox before you run the quick
installation tool. Note that templates for changing the
extension numbering plan are available from Mitel
Online.
To set up the voice mailboxes
- Connect an IP phone to a layer-2 switch port on
the controller.
- Program the mailboxes through the administration
set. See Log in to the administrator station (p. 70).
or
Program the mailboxes through the System Tool.
4. Open the Internet Explorer browser on your PC.
5. Enter the following URL:
http://192.168.1.2
Bookmark the Mitel 3100 ICP login page. The Mitel
Networks 3100 ICP login page opens.